Welcome to the 3rd Clinical Case of our StyleItaliano Special.
You can find the 1st article “Essential Lines: Aesthetic and functional simplified.” here and the 2nd article “Aesthetic and long lasting direct composite restoration in the anterior area” here.
Enjoy!
Learn more about the products used in this StyleItaliano special |
Initial Situation of a patient with an existed composite restorations and secondary caries on the lower molars.
Rubber dam application.
Dental Caries Removal with low speed bur and mechanical dentil chisel.
Dental Caries Detector application to check if all the cavity is clean.
Cleaned Cavities.
3M™ Scotchbond™ Universal Plus application after Selective Enamel Etching.
Bonding Polymerization after Air-Blowing Application.
Bulk Flow Composite Application (3M™ Filtek™ Bulk Fill flowable restorative A3) as a protective adhesive layer.
Bulk Composite Condensation (3M™ Filtek™ One A3) with the Compo-Vibes (Smile Line).
Bulk Composite Condensation (3M™ Filtek™ One A3).
Bulk Composite Adaptation (3M™ Filtek™ One A3) with a micro-brush.
Modeling completed, after using the Essential Lines technique and the LM-Arte™ Fissura (LM-Dental™).
Glycerine application and light curing for 20 seconds per each tooth surface.
Finishing and Polishing with 3M™ Sof-Lex™ Spirals.
Final result of the posterior direct composite restorations done in 30 minutes.
Refer to Instructions for Use (IFU) for complete product information. Results may vary.
Using 3M™ Scotchbond™ Universal Adhesive and 3M™ Filtek™ Supreme Ultra Universal Restorative.
Using 3M™ Single Bond Universal Adhesive, 3M™ Filtek™ Supreme Flowable Restorative, 3M™ Filtek™ Universal Restorative, 3M™ Elipar™ Deep Cure-S LED…
Using 3M™ Scotchbond™ Universal Adhesive, 3M™ Filtek™ One Bulk Fill Restorative, and the 3M™ Sof-Lex™ Spiral Finishing and Polishing system.
